Workshop : SV650 Cam Swap OEM Intake on Exhaust

This post has already been read 5251 times!

Note: The cams are remove with the F mark on the flywheel lined up with the mark on the casing. The front cams are taken out with the front cylinder at top dead center in the same position as if you were going to check your valve clearances. You turn the motor 360 degrees before doing the rear camshafts.

Front Cylinder
I had some oil on my lens
Rear Cylinder

This post has already been read 5251 times!

You may also like...

Leave a Reply

Shares